| Before hanging your wallcovering, it is very important
to properly prepare the walls, since this will make your job easier
and help ensure pleasing results. |
| |
| Unpainted/New
Walls: |
- Remove any switch and outlet plates.
- Make sure drywall (plasterboard) is thoroughly
dry.
- Fill in any nail holes or cracks with
spackling compound.
- Lightly sand walls to eliminate any imperfections.
- Remove dust by wiping walls with a clean,
damp sponge.
- Prime walls with a primer-sealer combination
to help the wallcovering adhere and prevent show-through.
|
| Painted Walls: |
- Remove any switch and outlet plates.
- Wash walls with a mild detergent.
- Fill in any nail holes or cracks with
spackling compound.
- Lightly sand walls to eliminate any
imperfections.
- Remove dust by wiping walls with a clean,
damp sponge.
- Prime walls with a primer-sealer combination
to help the wallcovering adhere and prevent show-through.
Note: Glossy or semi-glossy surfaces are too
slick for wallcovering to properly adhere.
|
| Previously Papered Walls |
- Remove any switch and outlet plates.
- Remove existing wallpaper.
- Wash walls with mild detergent to eliminate
residual adhesives.
- If walls were not previously primed-sealed,
we suggest that you prime and seal the walls to help the
wallcovering adhere and prevent show-through.
|
|
| |
NOTE:
We recommend priming & sealing the wall 1/4” less
than the actual size of the mural. This should eliminate the
need to
touch-up painted areas. |
| |
|
|
